BS ISO 13617:2019 download

09-22-2020 comment

BS ISO 13617:2019,Ships and marine technology — Shipboard incinerators — Requirements.BS ISO 13617:2019 pdf free download.
BS ISO 13617:2019 covers the design, manufacture, performance, operation, functioning and testing of incinerators intended to incinerate garbage and other shipboard wastes generated during a ship’s normal service (i.e. maintenance, operational, domestic and cargo-associated wastes).
BS ISO 13617:2019 is applicable to incinerator plants with capabilities up to 4 000 kW per unit.
BS ISO 13617:2019 is not applicable to systems on special incinerator ships, e.g. for burning industrial wastes such as chemicals, manufacturing residues, etc.
It does not address the electrical supply to the unit, nor the foundation connections and stack connections.
BS ISO 13617:2019 provides emission requirements in Annex A, location requirements in Annex B, and flue gas temperature requirements in Annex D. Recommendations for incinerators integrated with heat recovery units are given in Annex C.
The activities associated with this document can involve hazardous materials, operations and equipment. It does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this document to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2 Normative references
IEC 60092-201: 1994, Electrical installations in ships-Paurt 201: System design-General;
IEC 60092- 202: 2016, Electrical installations in ships- Part 202: System design-Protection;
IEC 60092-301: 1980, Electrical installations in ships- Part 301: Equipment- Generators and motors;
IEC 60092-352: 2005, Electrical installations in ships- Part 352: Choice and installation of cables for low-voltage power systems;
4 General design requirements
4.1 Piping
Piping for fuel and sludge oil shall be constructed of seamless steel of adequate strength and to the
tisfaction of the Administration. Short lengths of steel, or annealed copper nickel, nickel copper,
or copper pipe and tubing may be used at the burners. Non-metallic materials shall not be used for fuel lines, Valves and fittings may be threaded in sizes up to and including 60 mm outer diameter, but threaded unions shall not be used on pressure lines in sizes 33 mm outer diameter and over.
2 Rotating parts
rotating or moving mechanical and exposed electrical parts shall be protected by guards or shields against accidental contact by personnel in the vicinity of the incinerator.

                                           Related Information                                             Download
PS:Thank you for your support!
BS EN 12607-3-2000 pdf download BS Standards

BS EN 12607-3-2000 pdf download

BS EN 12607-3-2000 pdf download.Methods of test for petroleum and its products — BS 2000-460.3: Bitumen and bituminous binders — Determination of the resistance to hardening under the influence of heat and air — Part 3: RFT...
Read More
EN 12329-2000 pdf download BS Standards

EN 12329-2000 pdf download

BS EN 12329-2000 pdf download.Corrosion protection of metals — Electrodeposited coatings of zinc with supplementary treatment on iron or steel. This BS EN 12329 specifies requirements for electrodeposited coatings of zinc on iron or steel witt supplementary...
Read More
BS EN 1430-2000 pdf download BS Standards

BS EN 1430-2000 pdf download

BS EN 1430-2000 pdf download.Methods of test for petroleum and its products — BS 2000-292:Bitumen and bituminous binders — Determination of particle polarity of bitumen emulsions (Identical with IP 292-2000). This BS EN 1430 specifies a method...
Read More

LEAVE A REPLY

Anonymous netizen Fill in information