BS ISO 5597:2010 pdf free download.Hydraulic fluid power – Cylinders – Dimensions and tolerances of housings for single-acting piston and rod seals in reciprocating applications.
In hydraulic fluid power systems. power is transmitted and controlled through a liquid under pressure within an enclosed circuit. Sealing devices are used to contain the pressurized fluid with components having elements with linear motion, i.e. hydrau’ic cylinders. These sealing devices are used with both cylinder rod and piston seal housings.
BS ISO 5597:2010 is one of a series of standards covering dimensions and tolerances of housings.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 883, Indexable hardme ía! (carbide) inserts with rounded corners, without tixing hole — Dimensions
ISO 1302, Geometrical Product Specifications (GPS) — Indication of surface texture in technical product documentation
ISO 3274, Geometrical Product Specifications (GPS) — Surface texture: Profile method— Nominal characteristics of contact (stylus) instruments
ISO 4288, Geometrical Product Specifications (GPS) — Surface texture: Profile method — Rules and procedures for the assessment of surface texture
5 Seal housings
5.1 General
5.1.1 lustrated examples of typical hydraulic cylinder rod and piston seal housings covered by this International Standard are given in Figures 1 to 4.
NOTE: These figures are diagrammatic only and do not represent recommendations of a particular housing design.
5.1.2 All sharp edges and burrs shall be removed from corners of supporting surfaces and rounded although it should be borne in mind that these surfaces are required to provide maximum support against 5.1.3 The seal manufacturer shall be consulted for details of housing design that are not specified in this International Standard.