EN 2584-2001 pdf download.Aerospace series – Bearings, spherical plain in corrosion resisting steel with self-lubricating liner – Narrow series -Elevated load at ambient temperature – Dimensions and loads.
This EN 2584 specifies the characteristics of spherical plain bearings in corrosion resisting steel, with self- lubricating liner, narrow series, for elevated load at ambient temperature, with or without swaging groove, intended for use in the fixed or moving parts of the aircraft structure and control mechanisms.
They shall be used in the temperature range — 55C to + 163 C.
2 Normative references
This European Standard incorporates by dated or undated reference provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. Foc dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments).
ISO 1132-1 Rolling bearings — Tolerances — Part 1: Terms and definitions
ISO 8075 Aerospace — Surface treatment of hardenable stainless steel parts
EN 2030 Steel FE-PM43 — Hardened and tempered — Bars I) ≤ 150 mm — Aerospace series1)
EN 2132 Electrodeposition of chromium for engineering purposes — Aerospace series1)
EN 2424 Aerospace series — Marking of aerospace products
EN 2539 Aerospace series — Steel FE-PM3801 (X5CrNiCu17-4) — Air melted — Solution treated and precipitation treated — Bar — a or D ≤ 200 mm — R  965 MPa2)
EN 2755 Aerospace series — Bearings, spherical plain in corrosion resisting steel with self-lubricating liner — Elevated loads at ambient temperature — Technical specification2)
3 Symbols and definitions
The tolerance definitions are given in ISO 1132-1.
single plane mean bore diameter deviation
= deviation of a single bore diameter
single plane mean outside diameter deviation
= deviation of a single outside diameter
a = angle of tilt of the outer ring with respect to the inner ring, the spherical surface of the outer ring being completely in contact with the inner ring
6 Marking
According to EN 2424, style A
The marking position is at the manufacturer’s option.
Bearings ordered without technology code shall be delivered marked with the code of technology used.
7 Technical specification
According to EN 2755.EN 2584-2001 pdf download.