BS EN 507:2019 pdf download

12-17-2020 comment

BS EN 507:2019 pdf free download.Roofing and cladding products from metal sheet – Specification for fully supported products of aluminium sheet.
In this standard the performance of the product has been defined in terms of a number of type tests. The performance of a roof or cladding constructed with these products depends not only on the properties of the product as it is required by this document, but also on the design, construction and performance of the roof or the cladding as a whole in relation to the environment and conditions of use.
Metallic coated aluminium sheet can be easily fabricated. It can be sheared, punched, pressed, drawn, folded, roll-formed without difficulty within the given limits of the properties listed in the respective material specifications.
Coil coated sheet can be fabricated like metallic coated aluminium sheet in most applications, but minimum bend radius, design of forming tools, process temperature, etc. are chosen according to material properties.
BS EN 507:2019 specifies requirements for roofing and cladding products used for assembly into coverings for wall claddings, linings and pitched roofs, made from aluminium sheet with or without additional surface treatment (organic coating or anodising).
BS EN 507:2019 establishes general characteristics, definitions and labelling of the products, together with requirements for the materials from which the products can be manufactured. It is intended to be used either by manufacturers to ensure that their products comply with the requirements or by purchasers to verify that the products comply before they are despatched from the factory. It specifies the requirements for products which enable them to meet all normal service conditions. Products can be prefabricated or semi-formed products as well as strip, coil and sheet for on-site-formed applications (e.g. standing seam roofs).
BS EN 507:2019 applies to all discontinuously laid and fully supported roofing and cladding products made of aluminium sheets. No requirements for supporting construction, design of roof system and execution of connections and flashings are included.
BS EN 507:2019 does not apply to self-supporting aluminium sheets that are covered by EN 508-2.

Download infomation Go to download
Note: If you can share this website on your Facebook,Twitter or others,I will share more.
BS 7803:1995 pdf download BS Standards

BS 7803:1995 pdf download

BS 7803:1995 pdf download.Guide to insulators of ceramic material or glass for overhead-lines with a nominal voltage greater then 1000 V, puncture testing.(IEC 61211:1994) A power frequency puncture test on insulators in oil was specified in IEC...
Download Now
NA to BS EN 1991-1-1:2002 pdf download BS Standards

NA to BS EN 1991-1-1:2002 pdf download

NA to BS EN 1991-1-1:2002 pdf download.UK National Annex To Eurocode 1: Actions On Structures - Part 1-1:General Actions. Densities, Self-Weight, Imposed Loads For Buildings. This National Annex has been prepared by BSI Subcommittee B/525/1, Actions(loadings)and basis...
Download Now
BS EN 2020:1989 pdf download BS Standards

BS EN 2020:1989 pdf download

BS EN 2020:1989 pdf download.Specification for bearings - airframe rolling single row self aligning roller bearings in corrosion resisting steel diameter series 3 and 4 - Dimensions and loads. This standard specifies the characteristics, of rigid single...
Download Now

LEAVE A REPLY

Anonymous netizen Fill in information