SAE AS 39029-60-2000 pdf download CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE, SHIELDED, SIZE 8 (FOR MIL-C-38999 SERIES I, III, AND IV CONNECTORS)
Contact engagement and separation forces: The engagement depth shall be as encountered in normal service. The testpins shall be in accordance with MS3197, except the diameters shall be as specified in table Vl and surface roughnessshall not exceed 3.
Crimp tensile strength (inner and outer contact crimp joint): See table Vll.
Random vibration: Method 2005 of MIL-STD-1344, test condition V. The following details shall apply:
a.Use the vibration envelope shown on figure 3, derived from zone 2 outlined in Aerospace information report(AIR 1557).
b.Vibration: To be conducted at under standard test conditions.
CDuration: Eight hours in the longitudinal direction and 8 hours in a perpendicular direction (16 hours)
High impact shock: All contacts shal be wired in a series circuit with 100 miliamperes maximum current flow through theseries circuit during shock. Connectors shall be monitored for any discontinuities. A detector capable of detecting alldiscontinuities in excess of 1 microsecond shall be used. Wired and mated connectors shall be subjected to the testspecified in MIL-S-901, arade A with the folowina modifications and additions. Mounting fixture shall be in accordance withMIL-S-901, light weight.The cable or wire bundle shall be supported on a stationary frame to provide a free flexing cablelength between the frame and fixture of not less than 36 inches (914.4 mm).
Coupling. Coupled by normal mounting means.a.Test condition A. Plug shall be terminated with at least 80 percent of wired contacts. The wire bundle shall be providedbwith straight, open frame, strain relief accessory hardware.
Dielectric withstanding voltage (applied between inner and outer contact): See table Vll.
Operating temperature range: -65C (-85F) to 200C (392F)
Part or ldentifying number (PIN): See table IX.
QPL evaluating activity: Defense Electronics Supply Center (DESC-E), Dayton, OH 45444.
International interest: NEPR 57
Contacts shall comply with reliability assurance provisions of MIL-STD-790 as specified in MIL-C-38999